LinkSprite pcDuino
From linux-sunxi.org
| LinkSprite pcDuino | |
|---|---|
 | |
| Manufacturer | Linksprite |
| Dimensions | 125mm x 52mm x heightmm |
| Release Date | February 2013 |
| Website | Product Page |
| Specifications | |
| SoC | A10 @ 1Ghz |
| DRAM | 1GiB DDR3 @ 408MHz |
| NAND | 2GB |
| Power | DC 5V @ 2A |
| Features | |
| Video | HDMI (Type A - full) |
| Audio | HDMI |
| Network | 10/100Mbps Ethernet (Manufacturer device) |
| Storage | µSD |
| USB | 2 USB2.0 Host, 1 USB2.0 OTG |
This page needs to be properly filled according to the New Device Howto and the New Device Page guide.
The pcDuino is an A10 based development board with Arduino compatible headers.
Contents |
Identification
For a development board, explain the name(s) printed on the board.
Sunxi support
Current status
Supported.
Images
HW-Pack
BSP
Manual build
- For building u-boot, use the "pcDuino" target.
- The .fex file can be found in sunxi-boards as pcduino.fex
Everything else is the same as the manual build howto.
Mainline kernel
Use the sun4i-a10-pcduino.dts device-tree file for the mainline kernel.
Tips, Tricks, Caveats
FEL mode
The something button triggers FEL mode.
Adding a serial port
Describe how to find the RX,TX,GND signals here, and mention the UART howto.
Pictures
Take some pictures of your device, upload them, and add them here.
Also known as
List rebadged devices here.
